www.madmaxmovies.com

Here's a quick heads-up about an option for the Abbyshot MFP badge.

I wore the badge on the outside of my right boot, like in the movie. But all that is there to hold it on is that little pin. I found that it was very easy to accidently brush my leg against just about anything and dislodge the pin. Not fun if you lose a $40 dollar badge like that. Eventually, the pin broke off. So, I soldered four nickel-plated rivets to the back of the badge (the badge is copper) and just rivetted it to my boot. Now it's on there rock solid.

Just a helpful tip from HUMVEE Driver!

Thanks for sharing HUMVEE!

Yeah, the pin on the Abbyshot badge sucks. I've nearly lost both of my badges because of it.
Soldering and riveting is a great permanent solution.
But if you're not up to soldering, you can do what I did and tear the original pin off, and then use a product like JB KWIK to glue a couple of clutchback pins onto the back of the badge. I did this for both my boot and jacket badge.